Create this project yourself with sheet material cut to size by OPMAATZAGEN.nl!

maurice

Average

2 minutes

Description

A change from my current speaker to another smaller design.

A completely different concept and appearance, while retaining the current drivers.

Custom speaker conversion

As shown in the 1st photo, this was quite a design.
And I wanted to switch from a white to a black speaker.

So came out after a test setup (photo 2) to a detail drawing.

After some deliberation, I wanted to give it a try in made.
detail drawing made, dimensions came up.
So I switched to ordering, this was very clear and easy.

I was also surprised how quickly I could collect the wood.
So there were 3 boxes, and neatly packaged.
The codes I had made and those were also easy. had stuck them on it.

Then the dustiest work began, milling all the holes.
Pffff what a dust,
My advice, a good dust extraction and face mask.
br />When milling, I immediately noticed that it has a nice density, a completely different quality than from the hardware store.
Most of it is glued, but there are screws here and there that you don't see.
Here too, I noticed that the material does not crumble as much as the MDF from the hardware store.

Is it ultimately more expensive than a sheet at the hardware store, YES.
But this accuracy of how it is sawn word and the better quality material make it all worth it